Tucson AWD L4-2.0L (2007)
Installation
TPMS SENSOR
INSTALLATION
SENSOR FIT
CAUTION: Handle the sensor with care. Avoid lubricant contact if possible.
1. Assemble valve to sensor and turn valve 3 times with the square part of the screw in the slot.
CAUTION:
^
The fit should not be tight i.e. it should still be possible to easily adjust valve angle.
^
Ensure that the wheel to be fitted is designed for sensor mount. There should normally be a mark to indicate this.
^
Ensure that the valve hole and mating face of the wheel are clean.
2. Mount assembly to wheel.
CAUTION: Ensure sensor feet are against the wheel throughout the remainder of the assembly process.
3. Tighten washer and nut by hand until the valve thread meets the nut built-in calibrated stop.
CAUTION: Ensure that the grommet remains in contact with the wheel.
