Tucson AWD L4-2.0L (2007)
CAUTION: Use the grease included in the repair kit.
4. Apply the specified grease to the cage and fit the balls into the cage.
5. Position the chamfered side (A) as shown in the illustration. Install the inner race on the driveshaft (B), and then the snap ring.
6. Apply the specified grease to the outer race and install the BJ. outer race onto the driveshaft.
7. Apply the specified grease into the DOJ boot and install the boot with a clip.
8. Tighten the DOJ boot bands.
9. Add the specified grease to the BJ as much as wiped away at inspection.
10. Install the boots.
11. Tighten the BJ boot bands.
12. To control the air in the DOJ boot, keep the specified distance between the boot bands when they are tightened.
Installation
REAR DRIVESHAFT (DOJ-BJ TYPE)
