Tucson AWD L4-2.4L (2010)
24. Install the RH side cover.
Tightening torque :
8.8 - 10.8N.m (0.9 - 1.1kgf.m, 6.5 - 7.9lb-ft)
25. Install the RH front wheel.
Tightening torque :
88.3 - 107.9N.m (9.0 - 11.0kgf.m, 65.1 - 79.6lb-ft)
26. Install the engine cover (B).
27. Reconnect the battery negative cable (A).
Tightening torque:
(-) terminal : 4.0 - 6.0N.m (0.4 - 0.6kgf.m, 3.0 - 4.4lb-ft)
NOTE:
-
Refill engine oil.
-
Clean the battery posts and cable terminals with sandpaper. Assemble and then apply grease to prevent corrosion.
-
Inspect for fuel leakage.
-
After assembling the fuel line, turn on the ignition switch (do not operate the starter) so that the fuel pump runs for approximately two seconds
and fuel line pressurizes.
-
Repeat this operation two or three times, then check for fuel leakage at any point in the fuel lines.
-
Refill radiator and reservoir tank with engine coolant.
-
Bleed air from the cooling system.
-
Start engine and let it run until it warms up. (Until the radiator fan operates 3 or 4 times.)
-
Turn Off the engine and let it cool down. Check the level in the radiator, add coolant if needed. This will allow trapped air to be removed from
the cooling system.
-
Put radiator cap on tightly, then run the engine again and check for leaks.
