Tucson AWD L4-2.4L (2010)
Use a rubber hammer to tap the valve body cover on a corner until the cover is loose.
10. Use a small screwdriver to pry the connector from the oil temperature sensor.
11. Replace the oil temperature sensor with a new part.
Torque: 7.2-8.7 lb-ft (1.0-1.2 kgf.m)
12. Apply Permatex Ultra Gray Sealer or Hyundai Ultra Gray Gasket Sealer, P/N 00231-13800 to the valve body cover and reinstall the cover.
Torque: 7.2-8.7 lb-ft (1.0-1.2 kgf.m)
13. Add approximately five quarts of Hyundai SPH-IV ATF (P/N 00232-19045). Refer to TSB 09-AT-019 and check the level with the engine idling in
Park. Recheck the ATF level when the ATF is at normal operating temperature (122-140°F, 50-60°C).
14. Add ethylene glycol engine coolant to the radiator. Check the level according to the appropriate shop manual, Engine (EM) section, "Cooling
System".
15. Clear the codes and test drive the vehicle for two driving cycles (two key-on to key-off driving cycles, including 1-2-3-4-5-6 upshifts and 6-5-4-3-2-1
downshifts). If the DTC returns, perform the repairs shown above.
