Tucson AWD L4-2.4L (2010)
Fuel Tank Pressure Sensor: Service and Repair
Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2. Remove the rear seat .
3. Remove the fuel pump service cover (A).
4. Disconnect the fuel tank pressure sensor connector (A).
5. Remove the fuel tank pressure sensor after releasing the hooks vertically.
Installation
CAUTION:
-
Install the component with the specified torques.
-
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
CAUTION:
-
Insert the sensor in the installation hole and be careful not to damage when installation.
1. Installation is reverse of removal.
