Tucson AWD L4-2.4L (2010)
Seat Occupant Sensor: Procedures
PODS Re-zero procedure
You should perform PODS Re-zero procedure after service or replacement about all part of the passenger seat.
1. Ignition "OFF", connect GDS.
2. Ignition "ON" & Engine "OFF", select Airbag system and "PODS Reset" mode.
3. The GDS will show the two PODS RESET function steps.
(1) Erase PODS diagnostic codes.
(2) PODS initialization.
CAUTION:
This step must be done PODS re-zero, when the front passenger seat is empty.
4. Press the OK button to erase the PODS related diagnostic codes.
5. Press OK button to initialize the PODS.
