Tucson AWD L4-2.4L (2010)
3. If the test results show:
^
"Success - the wiring harness currently has no open/short circuit. Go to Step 5.
^
"Failure -the solenoids or wiring harness has an open/short circuit. Go to Step 4.
4. Visually check the wiring harness between the PCM and transaxle for a damaged wire or connector. Check for a short circuit to ground. If so, repair
or replace the ECM control harness. Go to Step 5.
5. Refer to the DIG recorded in Step 1 and follow the repair procedure shown below:
6. Remove the battery.
7. Drain the radiator. Remove the lower radiator hose from the radiator.
8. Drain the ATF
