Tucson AWD L4-2.4L (2010)
Pressure Plate: Service and Repair
Repair Procedures
Replacement
1. Remove a transaxle assembly. .
2. Remove the clutch cover bolts. Not to be bent or twisted, loosen them in diagonal directions.
3. Remove the clutch cover(A) and disc(B).
4. Using the SST(09411-11000), install a disc(A).
CAUTION:
-
Apply grease on a disc spline part and transmission input shaft spline part as required.
-> How to do: apply grease(CASMOLY L9508) 0.2gr. on the transmission input shaft spline part.
* Possible problems when not following
-
When not applying: Excessively wear of splines and bad clutch operation
-
When excessively applying: Scattered grease by centrifugal force contaminates the clutch disc. Loss of friction force can cause a slip
-
The 'T/M SIDE' marked surface should face the transaxle.
-> If the surface face the opposite side, there can be an interference between a disc and a flywheel surface.