Tucson AWD V6-2.7L (2009)
[4WD]
2. Before installing the driveshaft(C), set the opening side of the circlip(D) facing downward.
3. After installation, check that the driveshaft cannot be removed by hand.
4. Install the BJ. Into the knuckle.
5. Install the lower arm mounting bolts(A).
Tightening torque
100 - 120Nm (1000 - 1200Kgf-cm, 73.8 - 88.5lbf-ft)
6. After installing the washer(B) with convex surface outward, install the castle nut(A) and the split pin(C).
Tightening torque
200 - 280Nm (2000 - 2800Kgf-cm, 147.5 - 206.6lbf-ft)
