Tucson FWD L4-2.0L (2007)
5.
Release the squib wiring harness from the harness retaining clip.
a.
Using a small flat blade screwdriver, release the locking tab of the squib connectors and remove the connectors from the inflator.
Note that the connectors are both color coded and uniquely indexed to prevent cross-installation.
6.
Using an 8 mm socket and driver, remove the (4) air bag inflator mounting nuts from the existing air bag module.
7.
Remove the existing air bag inflator and save it for transfer to the new air bag cover module.
NOTE:
The existing air bag cover module must be scrapped. Refer to information in "Important notes to remember during installation" for directions.
8.
Remove the black plastic air bag inflator opening shipping protection cover from the new DAB cover module and discard it.
9.
Align the index hole on the inflator to the indexing mark on the new air bag cover module and attach it using the new supplied mounting nuts.
Re-assembly tightening torque: 5 - 7 lb.ft.
Note that the inflator can only be installed in the correct orientation.
