Tucson FWD L4-2.0L (2007)
REASSEMBLY
1. Install the spring lower pad (D) so that the protrusions (A) fit in the holes (C) in the spring lower seat (B).
2. Compress coil spring using special tool (09546-26000).
Install compressed coil spring into shock absorber.
NOTE:
a. Two identification color marks are indicated on the coil spring; one follows model option the other follows load classification. Pay attention to
distinguish between the two marks and then install them.
b. Install the cog spring with the identification mark directed toward the knuckle.
3. After fully extending the piston rod, install the spring upper seat and insulator assembly.
4. After seating the upper and lower ends of the coil spring (A) in the upper and lower spring seat grooves (B) correctly, tighten new self-locking nut
temporarily.
5. Remove the special tool (09546-26000).
6. Tighten the self-locking nut to the specified torque.
Tightening torque 40 - 55 Nm (400 - 550 kgf-cm, 29.5 - 40.6 ft. lbs.)
Inspection
REAR STRUT ASSEMBLY
INSPECTION
1. Check the insulator for wear or damage.
2. Check rubber parts for damage or deterioration.
