Tucson FWD L4-2.0L (2007)
1. Inspect the play of the bearing while the vehicle is jacked up.
2. If there is any play, loosen the wheel nuts slightly. Raise the rear of the vehicle, and make sure it is securely supported.
3. Remove the rear wheel and tire (A) from rear hub (B).
CAUTION: Be careful not to damage the hub bolts (C) then remove the rear wheel and tire (A).
4. Remove the split pin (A), then remove castle nut (B) and washer (C) from the rear hub while applying the brake.
5. Tighten the hub bearing nut by the following procedures.
a. Hub bearing nut must be fastened with torque 28 kgf-m and rear hub must be rotated above 3 times enough to secure placement of hub bearing.
b. Unfasten hub bearing nut until its tightening torque is 0 Kgf-m
