Tucson FWD L4-2.0L (2007)
glass flange.
-
Do not scrape down to the painted surface of the body; damaged paint will interfere with proper bonding.
-
Mask off surrounding surfaces before painting.
-
Remove the fasteners from the body.
2. Clean the body bonding surface with a sponge dampened in alcohol. After cleaning, keep oil, grease and water from getting on the surface.
3. With a sponge, apply a light coat of glass primer along the edge of the quarter fixed glass as shown, then lightly wipe it off with gauze or
cheesecloth:
-
Do not apply body primer to the quarter fixed glass, and do not get body and glass primer sponges mixed up.
-
Never touch the primed surfaces with your hands. If you do, the adhesive may not bond to the quarter fixed glass properly, causing a leak after
the quarter fixed glass in installed.
-
Keep water, dust, and abrasive materials away from the primed surface.
4. With a sponge, apply a light coat of body primer to the original adhesive remaining around the flange. Let the body primer dry for at least 10
minutes.
-
Do not apply glass primer to the body, and be careful not to mix up glass and body primer sponges.
-
Never touch the primed surfaces with your hands.
5. Pack adhesive into the cartridge without air pockets to ensure continuous delivery. Put the cartridge in a caulking gun, and run a bead of sealant
(A) around the edge of the quarter fixed glass (B) as shown. Apply the adhesive within 30 minutes after applying the glass primer. Make a slightly
thicker bead at each corner.
