Tucson FWD L4-2.4L (2011)
7. The progress bar will indicate when reprogramming reaches 100%. Wait until the next screen indicates reprogramming is complete.
8. The GDS will confirm that TCM reprogramming is successfully finished. Turn the ignition switch off for at least 10 seconds then turn back ON. Click
OK. If not successful, go to, 1-2. MANUAL TCM UPDATE PROCEDURE.
9. Check for Diagnostic Trouble Codes and erase any DTC present.
10. Reset the TCM adaptive learning values using the GDS "Option Treatment" menu on the main screen.
11. Start the engine to confirm proper operation.
1-2. MANUAL MODE TCM UPDATE PROCEDURE:
^ The manual update should be performed only if the automatic update fails.
^ If automatic update falls, disconnect the ECM connectors for 10 minutes and then reconnect them before performing the manual update.
1. From the GDS home screen, select ECU Upgrade. If necessary, select the VIN.
2. Select Manual Mode and click Next.
3. From the System tab, select AT and click Next.
4. Upgrade Event 212 LM TCM Upgrade will display. Select Next.
5. The ROM ID will display. Select Upgrade.
6. Refer to the table below and select the password. Click OK.
7. If the results indicate "Voltage is OK", select OK. If not, select CANCEL and charge the vehicle battery.
8. The progress bar will indicate when reprogramming reaches 100%. Wait until the next screen indicates reprogramming is complete.
9. The GDS will confirm that TCU reprogramming is successfully finished. Turn the ignition key OFF for 10 seconds and click OK.
10. Check for Diagnostic Trouble Codes (DTCs) and erase any DTC(s) present.
11. Reset the TCM adaptive learning values using the GDS "Option Treatment" menu.
12. Start the engine to confirm proper operation.
WARRANTY INFORMATION
NOTE:
Enter claim on Campaign Claim Entry Screen
