Tucson FWD V6-2.7L (2009)
-
Do not install the parts if five minutes or more have elapsed since applying the liquid gasket. Instead, reapply liquid gasket after removing
the residue.
-
After assembly, wait at least 30 minutes before filling the engine with oil.
(3) Place a new O-ring on the cylinder block.
(4) Engage the spline teeth of the oil pump drive gear with large teeth of the crankshaft, and slide the oil pump on the crankshaft.
(5) Install the oil pump with 5bolts.
Uniformly tighten the bolts in several passes.
Tightening torque
12 - 15Nm (1.2 - 1.5kgf.m, 8.8 - 11lb-ft)
4. Apply a light coat of oil to the seal lip.
5. Using the special tool(09214-33000), install the oil seal.
6. Install the upper oil pan.
(1) Using a razor blade and gasket scraper, remove all the old packing material from the gasket surfaces.
NOTE:
Check that the mating surfaces are clean and dry before applying liquid gasket.
(2) Install the oil pan(A) with the 17bolts.
Uniformly tighten the bolts in several passes.
Tightening torque
18.6 - 23.5Nm (1.9 - 2.4kgf.m, 13.7 - 17.4lb-ft) : (1 - 15)
4.9 - 6.9Nm (0.5 - 0.7kgf.m, 3.6 - 5.1lb-ft) : (16,17)
