Veracruz AWD V6-3.8L (2007)
2) Check that the mark (A) of the camshaft timing sprockets are in straight line on the cylinder head surface as shown in the illustration.
If not, turn the crankshaft one revolution (360 degrees)
NOTE: Do not rotate engine counterclockwise
6. Inspect the valve clearance.
1) Check only the valve indicated as shown. [No. 1 cylinder: TDC/Compression] measure the valve clearance.
Measurement method.
-
Using a thickness gauge, measure the clearance between the tappet and the base circle of camshaft.
-
Record the out-of-specification valve clearance measurements. They will be used later to determine the required replacement adjusting
tappet.
Valve clearance
Specification
Engine coolant temperature: 20 degrees C [68 degrees F]
Limit
Intake: 0.17 - 0.23 mm (0.0067 - 0.0090 in.)
Exhaust: 0.27 - 0.33 mm (0.0106 - 0.0129 in.)
2) Turn the crankshaft pulley one revolution (360 degrees) and align the groove with timing mark "T" of the lower timing chain cover.
NOTE: Do not rotate engine counterclockwise
3) Check only valves indicated as shown. [NO. 4 cylinder: TDC/compression]. Measure the valve clearance. (Refer to procedure step 1)
