Veracruz FWD V6-3.8L (2009)
(13) Connect the alternator connector (D) and the air compressor connector (E).
(14) Connect the LH front oxygen sensor connector (C).
(15) Connect the OCV connector (A) and the knock sensor connector (B).
(16) Connect the RH ignition coil connector.
(17) Disconnect the RH front and rear oxygen sensor connectors (A), the power steering sensor connector (B), the RH injector harness connector
(C) and the VIS solenoid valve connector (D).
32. Connect the ground cable (A) and tighten the power steering hose mounting bolt (B).
33. Install the engine mounting bracket (A).
Tightening torque
B: 78.5 - 98.0N.m (8.0 - 10.0kgf.m, 57.9 - 72.3lb-ft)
C: 63.7 - 83.4N.m (6.5 - 8.5kgf.m, 47.0 - 61.5lb-ft)
