Veracruz FWD V6-3.8L (2009)
40. Tighten all timing chain cover fasteners to specifications.
41. Apply a thin bead of liquid gasket and reinstall lower oil pan assembly.
42. Install new front main oil seal (as shown above).
NOTE:
Always refer to the applicable Shop Manual for published specifications.
43. Reinstall all the removed components in reverse order of removal.
NOTE:
When reattaching the LH upper mounting bracket to the transmission case hand-tighten all 4 bolts to snug and then final torque to specification.
NOTE:
Before reinstalling both valve covers, remove any old liquid gasket residue at the top surfaces between the timing cover and the cylinder heads. Reapply
liquid gasket to fill the seam points on the top surface between the timing cover and the cylinder head as shown (there are 2 seam points for each cylinder
bank).
^ Bead width: 0.1 in (2.5mm)
