Veracruz FWD V6-3.8L (2009)
Oil Filter: Removal and Replacement
Installation
Installation
Oil Pump
1. Install the oil pump(A).
Tightening torque
20.6 - 22.6Nm (2.1 - 2.3kgf.m, 15.2 - 16.6lb-ft)
NOTE:
Always use a new O-ring(B).
2. Install the oil pump sprocket(A) and the oil pump chain on the oil pump.
Tightening torque
18.62 - 21.56Nm (1.9 - 2.2kgf.m, 13.74 - 15.91lb-ft)
3. Install the oil pump chain cover(A).
Tightening torque
9.80 - 11.76Nm (1.0 - 1.2kgf.m, 7.23 - 8.68lb-ft)
4. Install the lower oil pan.
A. Using a gasket scraper, remove all the old packing material from the gasket surfaces.
B. Before assembling the oil pan, the liquid sealant TB1217H should be applied on upper oil pan.
The part must be assembled within 5 minutes after the sealant was applied.
Bead width :2.5mm(0.1in.)
But marked area(* ) to be 5.0mm(0.2in.)