Veracruz FWD V6-3.8L (2009)
CAUTION:
Be sure to select the correct vehicle and whether if has an immobilzer. Refer to the ECM part number label on back of the ECM if not sure.
^ IMMO = Vehicle with immmobilizer
^ NON IMMO = Vehicle without an immobilizer
3. The vehicle battery voltage is checked to make sure it is at least 12 volts to ensure reliable update results. Click OK if the results indicate Voltage is
OK.
NOTE:
If voltage is below 12 volts, click Cancel and then run the engine to ensure an adequate battery charge state for reliable update results.
4. Update will begin and the progress of the update will appear on the bar graph.
5. Updating will occur until 100% is reached on the bar graph. Turn the ignition key OFF for 10 seconds, place it back in the ON position and then click
OK to continue according to Information displayed on the screen.
6. Click OK on the final screen, which indicates update is complete.
WARNING:
For 2007 Vercruz after the update is completed, perform the VIN writing procedure and/or immobilizer key teaching procedure on the affected vehicles
with reference to the "3. ECM ROM ID INFORMATION".
