Veracruz FWD V6-3.8L (2009)
limit switch connectors.
NOTE:
Re-assembly tightening torque for the nuts and bolts: 10 ~ 13 lb.ft.
10. Locate the tilt and telescope limit switches, trace the wires back to their connectors, and remove the connector bodies (K & L) from the column by
releasing the connector's lock tab anchors.
11. Cut and remove the tilt motor connector harness wire tie.
NOTE:
The location of the wire tie and the adjacent harness to which it is attached. The new limit switch will be re-attached to the same harness.
12. Remove the telescope limit switch (O) and tilt limit switch (N) by removing the 4 screws as shown. Note the position of the steel bracket held in
place by the tilt switch lower mounting screw. This bracket provides a track for the telescope switch and must be re-installed with the new switches in the
same position.
13. Using the appropriate tool, lift up the tilt motor connector's pin lock as shown and set it aside.