Veracruz FWD V6-3.8L (2009)
7. Gently squeeze the sides of the upper half of the shroud to separate the upper and lower halves. Remove and set aside the upper half of the shroud.
Disconnect the power tilt & telescope switch connector from the lower half and set aside the lower half of the shroud.
8. Remove the ignition switch cover (H) by gently pulling it straight out.
9. Remove the steering column shaft support retaining nuts (I) and bolts (J) and slightly lower the steering column to get access to the tilt and telescope
limit switch connectors.
NOTE:
Re-assembly tightening torque for the nuts and bolts: 10 ~ 13 lb.ft.
10. Locate the tilt and telescope limit switches, trace the wires back to their connectors, and remove the connector bodies (K & L) from the column by
releasing the connector's lock tab anchors.