Veracruz FWD V6-3.8L (2009)
8. Insert the spring and flow control valve (B) into the pump body and then tighten the connector assembly (A).
Tightening torque :
70 - 80N.m (7.0 - 8.0kgf.m, 51 - 58lb-ft)
9. Assemble a new O-ring (B) and suction pipe (A) and then tighten the mounting bolts.
Tightening torque :
14 - 18N.m (1.4 - 1.8kgf.m, 10 - 13lb-ft)
10. Assemble the pump pulley (A) to pump shaft and then tighten the nut and spring washer together.
Tightening torque :
54 - 68N.m (5.5 - 6.9kgf.m, 40 - 50lb-ft)
Inspection
Inspection
1. Check that the flow control valve is not bent.
2. Check the shaft for wear and damage.
3. Check the V belt for wear and deterioration.
4. Check the grooves of the rotor and vanes for stratified abrasion.
5. Check the contact surface of the cam ring and vanes for stratified abrasion.
6. Check vanes for damage.
7. Check that there is no striped wear in the side plate or contacting part between the shaft and the pump cover surface.
