Veracruz FWD V6-3.8L (2009)
NOTE:
Some of the connectors on this switch panel are physically identical in shape. Pay special attention to the color of the connector body and the various
colored control stickers on the switch housings (i.e. the green connector body goes to the connector housing with the green control sticker, etc.)
5. Remove the knee bolster by removing the (4) 10mm bolts (F) as shown.
6. Remove the steering column shroud by first removing the (3) screws (G) as shown.
7. Gently squeeze the sides of the upper half of the shroud to separate the upper and lower halves. Remove and set aside the upper half of the shroud.
Disconnect the power tilt & telescope switch connector from the lower half and set aside the lower half of the shroud.
8. Remove the ignition switch cover (H) by gently pulling it straight out.
9. Remove the steering column shaft support retaining nuts (I) and bolts (J) and slightly lower the steering column to get access to the tilt and telescope
