Veracruz FWD V6-3.8L (2009)
4. Remove the brake caliper mounting bolts (A), and then place the brake caliper assembly (B) with wire.
5. Remove the tie rod end ball joint from the knuckle.
(1) Remove the split pin (A).
(2) Remove the castle nut (B).
(3) Disconnect the ball joint (C) from knuckle (D) using the special tool (09568-4A000).
CAUTION:
Apply a few drops of oil to the special tool. (Boot contact part)
6. Remove the split pin and the lower arm mounting bolt (B) from the knuckle (A).
7. Using a plastic hammer (A), disconnect driveshaft (C) from the axle hub (B).
