Veracruz FWD V6-3.8L (2009)
8. Push the axle hub (A) outward and separate the driveshaft (B) from the axle hub (A).
9. Remove the dust cover (A). (RH side)
10. Remove the mounting bolts of inner shaft bearing bracket assembly (A).
[Gasoline 3.8]
11. Separate the driveshaft (A) from the transaxle case (B).
CAUTION:
-
Do not use a pry bar to remove the driveshaft, as this may cause damage to the dust cover (A) and dust seal.
Remove the driveshaft after striking a pipe added on the joint case (B) with a hammer to prevent damage.