Veracruz FWD V6-3.8L (2009)
3. Remove the split pin (A), then remove castle nut (B) and washer (C) from the front hub under applying the brake.
4. Remove the mounting bolt (B) of the rear lower arm (A) and the rear carrier, while supporting the lower arm (A) with a jack as shown in the
illustration. Loosen the mounting bolt (C) of the cross member and the rear lower arm.
5. Remove the spring (A), the upper pad (B) and the lower pad (C).
6. Remove the rear shock absorber (A).
7. Remove the assist arm (A) and the trailing arm (B) from the rear axle carrier.
NOTE:
Remove the rear assist arm ball joint by using the special tool(09568-4A000).
