Veracruz FWD V6-3.8L (2009)
7. Using a sliding hammer, remove the taper roller bearing outer races(C) from the transfer cover(A) and housing(B).
8. Remove the oil seal(A) from the transfer cover.
Reassembly
NOTE:
1. Clean all parts except the taper roller bearings. Be careful about the direction of seals.
2. Oil bearings with hypoid gear oil API GL5.
3. Smear involute splines all covering with high pressure grease "Klueber microlube GNY202".
4. Measuring temperature: 20°±5°C.
5. O-ring has to be dipped into hypoid gear oil API GL5. Allow excess oil to drain.
6. Contact surface of the transfer housing to be coated with "SEALANT 732" or equivalent (silicon type sealing agent) prior to mounting. Coating
thickness: 0.1mm MIN. Prior to coating, mating surfaces must be clean and free from oil and grease.
7. Transfer oil specification : Hypoid gear oil "API GL5, SAE 75W/90 SHELL SPIRAX EQUIVALENT". Filled up to lower filler plug thread level(
Approx. 0.8L)
8. The hypoid gear set must be managed as a pair. Whenever installing or replacing a hypoid gear shaft assembly(47308-24000/24010) or a pinion
shaft(47311-39300/39310). Make sure to install or replace as a pair.
9. In reassembling, refer to the two figures below.
