Veracruz FWD V6-3.8L (2009)
16. Measure the dimension F.
F.. Assembled dimension of pinion assembly.
G.. Finished dimension of transfer housing.(=88.0mm)
E.. Mounting distance(=69.500 ± deviation).
17. Select the spacer thickness from the chart below. Thickness S1=E+F-G
NOTE:
If it is not possible to reach the exact mounting distance, select the next thinner spacer S1.
18. Install the pinion assembly with the selected spacer above and measure the circumference backlash on pinion.
(Measuring diameter, backlash and permissible deviations for measurement on pinion, see table below).
If the result is out of permissible range, change the spacer thickness S2, then start again with the step 8 - 12).
Tips For Spacer Adjustment For Hypoid Gear Backlash And Contact Pattern
