Veracruz FWD V6-3.8L (2009)
8. Remove the oil seal(A) from the transfer cover.
Reassembly
NOTE:
1. Clean all parts except the taper roller bearings. Be careful about the direction of seals.
2. Oil bearings with hypoid gear oil API GL5.
3. Smear involute splines all covering with high pressure grease "Klueber microlube GNY202".
4. Measuring temperature: 20°±5°C.
5. O-ring has to be dipped into hypoid gear oil API GL5. Allow excess oil to drain.
6. Contact surface of the transfer housing to be coated with "SEALANT 732" or equivalent (silicon type sealing agent) prior to mounting. Coating
thickness: 0.1mm MIN. Prior to coating, mating surfaces must be clean and free from oil and grease.
7. Transfer oil specification : Hypoid gear oil "API GL5, SAE 75W/90 SHELL SPIRAX EQUIVALENT". Filled up to lower filler plug thread level(
Approx. 0.8L)
8. The hypoid gear set must be managed as a pair. Whenever installing or replacing a hypoid gear shaft assembly(47308-24000/24010) or a pinion
shaft(47311-39300/39310). Make sure to install or replace as a pair.
9. In reassembling, refer to the two figures below.
1. Install the transfer drive gear with the taper roller bearings(47366-39000 and 47465-39000) into transfer housing.
2. Applying the preload(100 to 200N) to bearings, measure the dimension J.
3. Measure the dimension H on transfer cover(47314-24000).
4. Select the spacer thickness from the chart below. Thickness S4= H-J+K. (K: Bearing preload = 0.07 to 0.11mm. )
Corresponding preload torque(measured without seals) : 120 to 180Ncm.
