Veracruz FWD V6-3.8L (2009)
Reassembly
1. Assemble the taper roller bearing outer races.
2. Using a press machine, install the taper roller bearing(C) and the pinion shaft(A) in the pinion case(B).
3. Install the oil seal and the rear flange assembly as shown below and screw down the hex lock nut(A) until an axial clearance B of 0.25mm to
0.75mm between pinion and pinion case results.
(1) Measurement of B
A. Apply an additional 200N tension load F1 to the pinion head according to arrangement Y. Rotate the pinion 10 times and measure
dimension C.
B. Apply a 200N load F2 to the rear flange. Rotate the pinion 10 times and measure dimension D.
B=C-D