XG 350 V6-3.5L (2002)
Brake Caliper: Service and Repair
Removal and Installation
Front
REMOVAL
1. Remove the wheel and tire.
2. Remove the brake hose from the caliper.
3. Remove the caliper assembly.
INSTALLATION
1. Install the pads and brake cylinder.
2. Install the brake hose to the caliper.
3. Fill the brake reservoir with brake fluid.
4. Bleed the system.
Rear
REMOVAL
The procedure is the same as front disc brake pad.
INSPECTION
1. Check the pads for wear or oil contamination and replace if necessary.
NOTE: The pads for the right and left wheels should be replaced at the same time.
Pad thickness wear limit: 2.0 mm (0.08 inch)