XG 350 V6-3.5L (2002)
NOTE: Do not disconnect the brake hose.
5. Remove the pads.
CAUTION: Be careful not to depress the brake pedal while disassembling the pads.
INSPECTION
1. Check the pads for wear or oil contamination.
Replace or correct if necessary.
2. Check the shims for damage or deformation.
INSTALLATION
1. Install the pad clips.
2. Install the pads onto each pad clip.
NOTE:
a. All four pads must be replaced as a complete set.
b. When replacing the brake pad, check for deformation and then replace the guide spring with a new one or use it again after removing foreign
material.
3. Press in the piston with a hammer handle or equivalent.
4. Lower and insert the brake cylinder carefully so as not to damage the boot.
5. Install the two guide rod bolts and tighten. Tighten the connections to the specified torque.
Guide rod bolt : 22 - 32 Nm (220 - 320 kg-cm, 16 - 24 ft. lbs.)
