XG 350 V6-3.5L (2002)
Drive Belt Tensioner: Service and Repair
DRIVE BELTS TENSION ADJUSTMENT
1.Check that the belts are not damaged and fit properly into the pulley grooves.
CAUTION:
-
When installing the V-ribbed belt, check that the V-ribs are properly aligned.
-
If noise or slippage is detected, check the belt for wear, damage, or breakage on the pulley contact surface, and check the pulley for scoring.
Also check for the proper belt deflection measurement.
Standard Value
2. Apply 100 N (22 lbs.) force to the belt back midway between the pulleys as shown in the illustration, measure the amount of deflection with a
tension gauge.
Temporarily install hinge bolt and flange nut not to tensioner pulley run out -> Adjust belt tension -> Tighten adjust bolt and flange nut to the specified
torque.