XG 350 V6-3.5L (2002)
Blower Motor: Description and Operation
Manual
Circuit Description
Blower Control
When the ignition switch in ON, battery voltage is applied to the coil of the blower relay. With blower switch in any position except OFF, ground is
provided to the coil of the blower relay through the blower switch.
Battery voltage is then applied to the blower motor through the closed contacts of the blower relay, ground is provided to the blower motor through
blower resistor and blower switch for the desired blower motor speed. As the blower switch is moved from OFF to position 4, resistors in the resistor
block are bypassed. Decreasing the resistance will increase the current applied to the blower motor. This increases the blower motor speed.
When the fan switch is in position 4, all of the resistors are bypassed. The maximum current is now applied to the blower motor so that it runs at the
highest speed.
