XG 350 V6-3.5L (2002)
3. Remove the pulley retaining snap ring and then pull the pulley and bearing assembly from the compressor.
REASSEMBLY SERVICE POINT
1. After reassembling the compressor assembly as the reverse of disassembly procedure given, check the clutch air gap between the clutch hub and
the pulley mating surface with a feeler gauge. The air gap should be as follows.
Air gap: 0.35 - 0.65 mm (0.014 - 0.026 in.)
NOTE: When reassembling the compressor assembly, clean the pulley bearing surface and coil press diameter of the front head to remove any
dirt or corrosion.
2. If the clutch air gap is not within the dimensions specified above, adjust the various thickness shims until the air gap is between the specified
limits.