XG 350 V6-3.5L (2002)
9.
When the REPROGRAMMING COMPLETED message is displayed, the ECM reprogramming process is complete.
NOTE
^
The new ECM ID is displayed when the new ECM software download process is complete.
^
Check the new ECM ID displayed on the Hi-Scan Pro screen to verify that the correct ECM software has been downloaded. Refer to the
"ECM SPECIFICATION TABLE" for the ECM ID listing.
10.
Turn the Hi-Scan Pro off and turn the ignition key to the off position for 10 seconds. Then start the engine to check for proper operation.
Explanation of Error Message
1.
"INVALID PASSWORD": Please enter the correct password again.
2.
"REPROGRAMMING ERROR PLEASE WAIT FOR RETRY": An error occurred during reprogramming, the Hi-Scan Pro will retry the
reprogramming automatically.
3.
"ALREADY REPROGRAMMED" or "INCORRECT TARGET ID" : The reprogramming has previously been done on this vehicle or the ECM is
not the correct type for this reprogramming procedure.
4.
"REPROGRAM ERROR, PLEASE CHECK THE SYSTEM" : In this case you must reprogram manually after selecting the menu option "02.
XG300/350 REAR 02 SENSOR [ERROR]".
