XG 350 V6-3.5L (2002)
21. Install the bushing, rack support, yoke support spring and rack plug in the order shown. Apply semi-drying sealant to the threaded section of the
yoke plug support cover before installation.
22. With the rack placed at the center position, attach the yoke plug to the gear housing. Tighten the yoke plug within the range of 20 - 25 Nm (200 -
250 kg-cm, 14.5 - 18 ft. lbs.), using the special tool. Loosen the yoke plug for approximately 20° and tighten the locking nut to the standard value.
Standard value
Total pinion torque 0.6 - 1.3 Nm (6 - 13kg-cm, 0.4 - 0.9 ft. lbs.)
23. After adjusting, install the yoke plug with lock nut.
NOTE: When it cannot be adjusted within the specified return angle, check rack support plug components or replace.
24. Tighten the feed tube to the specified torque and in stall the mounting rubber with adhesive.
25. Apply the specified grease to the bellows mounting position (fitting groove) of the tie rod.
Recommended grease
Multipurpose grease SAE J310a, NLG1 #2 EP
26. Install the new attaching band to the bellows.
CAUTION: Whenever the bellows are installed, a new band must be used.
27. Install the bellows in, taking care not to twist it.
28. Fill the dust cover inner side and lip with the specified multipurpose grease, and place the dust cover in position with the clip ring attached in the
groove of the tie rod end.
Recommended grease Multipurpose grease SAE J310a, NLGI #2 EP
