XG 350 V6-3.5L (2002)
Axle Shaft Assembly: Service and Repair
Disassembly and Reassembly
FRONT DRIVESHAFT (G.I - A.C TYPE)
DISASSEMBLY
NOTE:
^
Do not disassemble the tripod assembly.
^
Special grease must be applied to the driveshaft joint.
^
The boot clamp should be replaced with a new one.
^
The boot should be replaced with a new one.
1. Using a side cutter, cut the G.I. and A.C. big clamps and remove them.
2. Using a brass bar and hammer, remove the G.I. and A.C. small clamps.
3. Place matchmarks on the tripod and tulip.
NOTE: Do not punch the mark.