XG 350 V6-3.5L (2002)
2. Place new clamps in the small boot ends and then install the boots on to the driveshaft.
3. After aligning the matchmark, place the beveled side of the tripod axial spline toward the A.C. joint.
4. Using a 19 mm socket and hammer, tap the tripod of the driveshaft.
5. Install a new snap ring.
6. Add the specified grease to the A.C. joint and boot as much as was wiped away at inspection.
7. Apply the specified grease to the G.I. joint and boot.
8. Align the matchmarks and install the G.I. joint to the shaft.
9. Install the boots.
NOTE:
^
Make sure that 2 boots are on the shaft groove.
^
Make sure that the 2 boots are not stretched.
10. Position the holes in the clamp's free end to the closing hooks.
