XG 350 V6-3.5L (2002)
The glass should be installed 10 minutes after you apply the primer.
10. Pack adhesive into the cartridge avoiding air pockets, to ensure continuous application. Put the cartridge in a caulking gun or sealant gun, and run
a bead of adhesive around the edge of the glass.
NOTE: Apply the adhesive within 5 minutes after applying the glass primer
Using the suction cups or the special tool (09861 - 31400), lower the glass over the opening to align it with the marks made in step 5 and set it
down on the sealant. Insert two lower spacers to prevent the rear window from moving downward.
11. Use suction cups or the special tool (09861 - 31400) to hold the rear window over the opening, align it with the alignment marks and set it down
on the adhesive. Lightly push on the rear window until its edges are fully seated on the adhesive all the way around.
NOTE: Do not open or close the doors until the adhesive is dry
12. Remove excess adhesive with a putty knife or gauze.
Fill any cavities around the rear window glass.
13. After one hour, perform a water-leak test for the windshield. Use a cold water spray, being careful not to direct a powerful stream of water on the
new adhesive material. Allow water to spill over the edges of the glass.
14. If there are leaks, dry the affected area, then apply sealant.
NOTE:
-
Let the car stand for at least four hours after windshield installation. If the car has to be used within the first 8 hours, it must be driven slowly
-
keep the windshield dry for the first hour after installation.
15. Install the removed parts.
