EX35 AWD V6-3.5L (VQ35HR) (2009)
Is the inspection result normal?
YES - GO TO 3.
NO - GO TO 2.
2.CHECK POWER RETURN SWITCH (RH) CIRCUIT
1. Disconnect rear seatback power return control unit connector.
2. Check continuity between rear seatback power return control unit harness connector and power return switch (RH) harness connector.
3. Check continuity between rear seatback power return control unit harness connector and ground.
Is the inspection result normal?
YES - Replace rear seatback power return control unit. Refer to See: Relays and Modules - Body and Frame/Power Seat Control Module/Service and
Repair/Removal and Installation.
NO - Repair or replace harness.
3.CHECK POWER RETURN SWITCH (RH) GROUND CIRCUIT
Check continuity power return switch (RH) harness connector and ground.
Is the inspection result normal?
YES - GO TO 4.
NO - Repair or replace harness.
4.CHECK POWER RETURN SWITCH (RH)
Check power return switch (RH). Refer to See: RH/Component Inspection.
Is the inspection result normal?
YES - GO TO 5.
NO - Replace power return switch (RH). Refer to See: Service and Repair/Power Return Switch/Removal and Installation.
5.CHECK INTERMITTENT INCIDENT
Refer to See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Intermittent Incident.
- INSPECTION END
Component Inspection
POWER RETURN SWITCH
RH : Component Inspection
1.CHECK POWER RETURN SWITCH (RH)
1. Turn ignition OFF.
2. Disconnect power return switch (RH) connector.
3. Check power return switch (RH) terminals.