EX35 AWD V6-3.5L (VQ35HR) (2009)
Blower Motor: Service and Repair
Blower Unit
BLOWER UNIT
BLOWER UNIT : Removal and Installation
REMOVAL
1. Remove instrument lower panel RH. Refer to See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Exploded View.
2. Disconnect AWD control unit connector (AWD). Refer to See: Powertrain Management/Transmission Control Systems/Relays and Modules -
Transmission and Drivetrain/Relays and Modules - Transfer Case/Control Module/Service and Repair/Exploded View.
3. Disconnect ECM (1) connectors.
4. Remove mounting nuts (A), and then remove ECM with bracket attached.
5. Remove power steering control unit. Refer to See: Steering and Suspension/Steering/Service and Repair/Exploded View.
6. Disconnect intake door motor connector and blower motor connector.
7. Remove mounting bolt (A) and screw (B), from blower unit (1).
8. Remove blower unit.
CAUTION:
Move blower unit rightward, and remove locating pin (1 part) and joint. Then remove blower unit downward.
INSTALLATION
Installation is basically the reverse order of removal.
CAUTION:
Make sure locating pin (A) and joint (B) are securely inserted.