EX35 AWD V6-3.5L (VQ35HR) (2009)
-
Push in tabs (1) and pull out fuel tube (2).
b. Removal of sub fuel level sensor unit:
i.
Remove retainer.
ii. Raise and release sub fuel level sensor unit to remove.
INSTALLATION
Note to the following, and install in the reverse order of removal.
Fuel tube
-
When installing fuel tube (1), refer to "Quick Connector".
Main and Sub Fuel Level Sensor Unit
-
Face main and sub fuel level sensor units as shown in the figure, and install them with the knock pin (C) on back aligned with pin hole on fuel
tank.
-
Install retainer so that its notch becomes parallel with the notch on fuel tank.