EX35 AWD V6-3.5L (VQ35HR) (2009)
Body Control Module: Service and Repair
Removal and Installation
BCM (BODY CONTROL MODULE)
Removal and Installation
CAUTION:
Before replacing BCM, perform "READ CONFIGURATION" to save or print current vehicle specification. See: Body and Frame/Body
Control Systems/Testing and Inspection/Programming and Relearning
REMOVAL
1. Remove dash side finisher (passenger side). Refer to See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Exploded
View.
2. Remove bolt and nut.
3. Remove BCM and disconnect the connector.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
-
Be sure to perform "WRITE CONFIGURATION" when replacing BCM.
-
Be sure to perform the system initialization (NATS) when replacing BCM. Refer to See: Body and Frame/Body Control Systems/Testing
and Inspection/Programming and Relearning/Configuration (BCM)/Special Repair Requirement.