EX35 AWD V6-3.5L (VQ35HR) (2009)
3.CHECK PRIMARY POSITION LIMIT SWITCH (LH) GROUND CIRCUIT
1. Check continuity between rear seatback power return control unit harness connector and primary position limit switch (LH) harness connector.
2. Check continuity between rear seatback power return control unit harness connector and ground.
Is the inspection result normal?
YES - GO TO 4.
NO - Repair or replace harness.
4.CHECK PRIMARY POSITION LIMIT SWITCH (LH)
Check primary position limit switch (LH). Refer to See: LH/Component Inspection.
Is the inspection result normal?
YES - GO TO 5.
NO - Replace primary position limit switch (LH) [seat device assembly (LH)]. Refer to See: Body and Frame/Seats/Service and Repair/Rear
Seat/Exploded View.
5.CHECK INTERMITTENT INCIDENT
Refer to See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Intermittent Incident.
- INSPECTION END
Component Inspection
PRIMARY POSITION LIMIT SWITCH
LH : Component Inspection
COMPONENT INSPECTION
1.CHECK PRIMARY POSITION LIMIT SWITCH (LH)
1. Turn ignition switch OFF.
2. Disconnect primary position limit switch (LH) connector.
3. Check primary position limit switch (LH) terminals.
Is the inspection result normal?
YES - Primary position limit switch (LH) is OK.
NO - Replace primary position limit switch (LH) [seat device assembly (LH)]. Refer to See: Body and Frame/Seats/Service and Repair/Rear
Seat/Exploded View.
Component Function Check
PRIMARY POSITION LIMIT SWITCH
RH : Component Function Check
1.CHECK FUNCTION
Check that the rear seatback (RH) rises when pressing and holding the power return switch (RH) or rear seatback switch (RH) in UP direction.
Is the inspection result normal?
YES - Primary position limit switch (RH) is OK.
NO - Refer to See: RH/Diagnosis Procedure.
Diagnosis Procedure
PRIMARY POSITION LIMIT SWITCH