EX35 AWD V6-3.5L (VQ35HR) (2009)
Radius Arm: Service and Repair
Removal and Installation
RADIUS ROD
Removal and Installation
REMOVAL
1. Remove tires with power tool.
2. Remove radius rod mounting bolt and nut (axle housing side).
3. Remove radius rod mounting bolt (rear suspension member side), and remove radius rod.
INSTALLATION
Note the following, and install in the reverse order of removal.
-
Perform final tightening of rear suspension member and axle installation position (rubber bushing), under unladen conditions with tires on level
ground.