EX35 AWD V6-3.5L (VQ35HR) (2009)
INSTALLATION
Note the following, and install in the reverse order of removal.
CAUTION:
-
Be careful not to damage connector when installing any connector.
-
Never reuse drain plug and drain plug gasket.
-
Never reuse O-ring.
-
Apply ATF to O-ring.
-
Adjust bolt hole of bracket to bolt hole of control valve with TCM when installing A/T fluid temperature sensor 2 (with bracket).
-
Refer to the followings when installing control valve with TCM to transmission case.
CAUTION:
-
Make sure that input speed sensor securely installs input speed sensor holes (B).
-
Hang down output speed sensor harness toward outside so as not to disturb installation of control valve with TCM.
-
Adjust A/T assembly harness connector of control valve with TCM to terminal hole of transmission case.
-
Assemble it so that manual valve (1) cutout is engaged with manual plate (2) projection.
- Install bolts (A), (B) and (C) to control valve with TCM. Tighten bolt