EX35 RWD V6-3.5L (VQ35HR) (2008)
CAUTION:
-
Disengage the clips slowly and carefully.
-
Do not pull the front door parting seal strongly.
3. Remove front door parting seal.
REAR DOOR PARTING SEAL (LOWER)
1. Fully open rear door.
2. Using a remover tool (A), disengage the clips from the rear door parting seal (1).
CAUTION:
-
Disengage the clips slowly and carefully.
-
Do not pull the rear door parting seal strongly.
REAR DOOR PARTING SEAL (FRONT)
1. Fully open front door.
2. Pull back rear door parting seal (front).
CAUTION: Do not bend the rear door parting seal strongly.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
-
When installing door parting seal, check that blind clips are securely fitted in panel holes on body, and then press them in.
-
When installing, check visually the fillet molding and the clips, then replace them with new parts if they have been damaged.
-
Replace double-faced adhesive tape on back of rear door parting seal (front) with a new tape if rear door parting seal (front) is reused.
-
Remove double-faced adhesive tape remaining on body and back of rear door parting seal (front) using double-faced adhesive tape
remover when removing rear door parting seal (front).
-
Do not wash the vehicle with in 24 hours after installing so as to keep adhesive.