EX35 RWD V6-3.5L (VQ35HR) (2008)
Vacuum Brake Booster: Service and Repair
Vacuum Lines
Removal and Installation
BR-31 Exploded View
REMOVAL
1. Remove the engine cover.
2. Remove the cowl top cover.
3. Remove the vacuum hose and tube.
INSTALLATION
Note the following, install in the reverse order of removal.
^
Because vacuum hose contains a check valve, it must be installed in the correct position. Refer to the stamp to confirm correct installation. Brake
booster will not operate normally if the hose is installed in the wrong direction.
^
When installing vacuum hose, insert it until its tip reaches the back-end of length (A) or further as shown in the figure.
Standard
A: 24 mm (0.95 in) or more
^
Face the marking side up when assembling.
CAUTION:
Never use lubricating oil during assembly.
Inspection